Popular Design for Mbr Treatment - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo
Popular Design for Mbr Treatment - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo Detail:
Applications
Drinking water treatment of tap water, surface water, well water and river water.
Pretreatment of RO.
Treatment, recycle and reuse of industrial waste water.
Filtration Performance
This product is proven to have below filtering effects according to the service?conditions of different water sources:
| Ingredient | Effect |
| SS, Particles?> 1μm | Removal Rate?≥ 99% |
| SDI | ≤ 3 |
| Bacteria, Viruses | >?4 log |
| Turbidity | < 1NTU |
| TOC | Removal Rate: 0-25% |
*Above data is obtained under the condition that feeding water turbidity is < 25NTU.
Product Parameters
Technical Parameters
| Filtering?Type | Outside-in |
| Membrane?Material | Modified?PVDF |
| MWCO | 200K Dalton |
| Membrane?Area | 47m2 |
| Membrane?ID/OD | 0.8mm/1.3mm |
| Dimensions | Φ200mm*1710mm |
| Connector?Size | DN50 Clamping |
Application Data
| Pure?Water?Flux | 9,400L/H?(0.15MPa, 25C) |
| Designed?Flux | 40-120L/m2.hr?(0.15MPa, 25C) |
| Suggested?Working?Pressure | ≤ 0.2MPa |
| Maximum?Transmembrane?Pressure | 0.15MPa |
| Maximum?Backwashing?Pressure | 0.15MPa |
| Air?Washing?Volume | 0.1-0.15N m3/m2 .hr |
| Air?Washing?Pressure | ≤ 0.1MPa |
| Maximum?Working?Temperature | 45C |
| PH?Range | Working: 4-10; Washing: 2-12 |
| Operating?Mode | Cross-flow?or?Dead-end |
Feeding Water Requirements
Before feeding water, a security filter < 50 μm should be set to prevent blockage caused?by large particles in raw water.
| Turbidity | ≤ 25NTU |
| Oil?&?Grease | ≤?2mg/L |
| Suspended?Solids | ≤ 20mg/L |
| Total?Iron | ≤?1mg/L |
| Continuous?Residual?Chlorine | ≤?5ppm |
| COD | Suggested?≤ 500mg/L |
*Material of UF membrane is polymer organic plastic, there must not be any organic solvents in raw water.
Operating Parameters
| Backwashing?Flow?Rate | 100-150L/m2.hr |
| Backwashing?Frequency | Every?30-60min. |
| Backwashing?Duration | 30-60s |
| CEB?Frequency | 0-4?times per day |
| CEB?Duration | 5-10min. |
| CIP?Frequency | Every 1-3 months |
| Washing?Chemicals: | |
| Sterilization | 15ppm Sodium Hypochlorite |
| Organic?Pollution?Washing | 0.2%?Sodium Hypochlorite + 0.1% Sodium Hydroxide |
| Inorganic?Pollution?Washing | 1-2% Citric?Acid/0.2% Hydrochloric?Acid |
Component Material
| Component | Material |
| Membrane | Modified?PVDF |
| Sealing | Epoxy?Resins |
| Housing | UPVC |
Product detail pictures:
Related Product Guide:
Our goods are commonly recognized and reliable by consumers and may satisfy continually developing economic and social needs for Popular Design for Mbr Treatment - UF Membrane Module 8 inch PVDF Ultrafiltration Membrane Module UFf200 Circuit Board Waste Water Treatment – Bangmo , The product will supply to all over the world, such as: Buenos Aires , Serbia , Suriname , In order to make more people know our products and to enlarge our market, we have devoted a lot of attention to technical innovations and improvement, as well as replacement of equipment. Last but not the least, we also pay more attention to training our managerial personnel, technicians and workers in planned way.
By Eleanore
from Australia
- 2018.10.01 14:14
The factory has advanced equipment, experienced staffs and good management level, so product quality had assurance, this cooperation is very relaxed and happy!
By Rae
from Swiss
- 2017.11.12 12:31
Write your message here and send it to us
