Send Email
Facebook
Twitter
Linkedin
Youtube
MCR Membrane Module Reinforced PVDF BM-SLMCR-20 RO Pretreatment
Product?Overview
Submerged ultrafiltration (MCR) Technology is a water treatment technology which combines membrane technology and physico-chemical precipitation process. High-precision sludge-water separation of outlet from coagulation sedimentation tank can ?be? done? by? submerged? ultrafiltration? (MCR),? high? filtering? precision? of memrbane insures high quality and clear water outlet.
This product adopts reinforced modified PVDF material, which will not peel or break ?during? backwashing,? meanwhile? it? has? good? permeable? rate,? mechanical performance, chemical resistance and anti-fouling? ability. ID? & OD of reinforced hollow fiber membrane are 1.0mm and 2.2mm respectively, filtering precision is 0.03 micron.? Filtering? direction? is? outside-in,? that? is raw? water,? driven by? differential pressure, permeates into the hollow fibers, while bacteria, colloids, suspended solids and microorganisms etc. are rejected in the membrane tank.
Applications
● Purification of surface water;
● Reuse of heavy metal waste water;
● Pretreatment of RO.
Filtration?Performance
Below? filtration? effects? are? proved? according? to? the? use? of modified ?PVDF hollow fiber ultrafiltration membrane in different types of water:
| No. | Item | outlet water index |
| 1 | TSS | ≤1mg/L |
| 2 | Turbidity | ≤ 1 |
Specifications
Size
Chart 1 MBR Size
Technical?Parameters:
| Filtering Direction | Outside-in |
| Membrane Material | Reinforced Modified PVDF |
| Precision | 0.03? micron |
| Membrane Area | 20m2 |
| Membrane ID/OD | 1.0mm/ 2.2mm |
| Size | 785mm×1510mm×40mm |
| Joint Size | DN32 |
Component?Material:
| Component | Material |
| Membrane | Reinforced Modified PVDF |
| Sealing | Epoxy Resins + Polyurethane (PU) |
| Housing | ABS |
Using?Conditions
Proper?? pretreatments ??must?? be?? set?? when?? raw?? water?? contains?? a?? lot?? of impurities/coarse particles or large proportion of grease. Defoamer must be used to remove ?foams? in membrane tank when necessary, please use? alcoholic? defoamer which is not easy to scale.
| Item | Limit | Remark |
| PH Range | 5-9 (2- 12 when washing) | Neutral PH is better for bacterial culture |
| Particle Diameter | <2mm | Prevent sharp particles to scratch membrane |
| Oil & Grease | ≤2mg/L | Prevent membrane fouling/sharp flux decrease |
| Hardness | ≤150mg/L | Prevent membrane scaling |
Application?Parameters:
| Designed Flux | 15~40L/m2.hr |
| Backwashing Flux | Twice the designed flux |
| Operating Temperature | 5~45°C |
| Maximum Operating Pressure | -50KPa |
| Suggested Operating Pressure | ≤-35KPa |
| Maximum backwashing Pressure | 100KPa |
| Operating Mode | Continuous opeartion, intermittent backwashing air flushing |
| Blowing Mode | Continuous Aeration |
| Aeration Rate | 4m3/h.piece |
| Washing Period | Clean water backwashing every 1~2h; CEB every 1~2 days;Offline washing every 6~12 months(Above information is for reference only, please adjustaccording to actual differential pressure change rule) |